Skil 5680-02 Manual de Utilização e Manutenção descarregar pdf (Página 14)

-14-

Trouble Shooting

Read instruction manual first! Remove plug from the power source before

making adjustments or assembling the blade.

TROUBLE: SAW WILL NOT START

PROBLEM 1. Power cord is not plugged in.

2. Power source fuse or circuit breaker tripped.

3. Cord damaged.

4. Burned out switch.

5. Trigger does not turn tool on.

REMEDY 1. Plug saw in.

2. Replace fuse or reset tripped circuit breaker.

3. Inspect cord for damage. If damaged, have cord replaced by an Authorized Skil

Service Center or Service Station.

4. Have switch replaced by an Authorized Skil Service Center or Service Station.

5. Disengage Safety Switch as described on page 9

TROUBLE: BLADE DOES NOT COME UP TO SPEED

PROBLEM 1. Extension cord too light or too long.

2. Low house voltage.

REMEDY 1. Replace with adequate cord.

2. Contact your electric company.

TROUBLE: EXCESSIVE VIBRATION

PROBLEM 1. Blade out of balance.

2. Workpiece not clamped or supported properly.

REMEDY 1. Discard Blade and use different blade.

2. Clamp or support workpiece as shown on pages 9, 11 and 12.

TROUBLE: CANNOT MAKE SQUARE CUT WHEN CROSSCUTTING

PROBLEM 1. Foot not adjusted properly.

REMEDY 1. See “Operating Instructions” section, “Bevel Adjustment” (page 9), “Line Guide”

(page 10, “Cutting Large Sheets (page 12) and “Rip Cuts” (page 12).

TROUBLE: CUT BINDS, BURNS, STALLS MOTOR WHEN RIPPING

PROBLEM 1. Dull blade with improper tooth set.

2. Warped board.

3. Blade binds.

4. Improper workpiece support.

REMEDY 1. Discard blade and use a different blade.

2. Make sure concave or hollow side is facing “DOWN” feed slowly, see (page 12).

3. Assemble blade and tighten Vari-Torque clutch per “Assembly Instructions”, see

(page 8)

4. Clamp or support workpiece as shown on pages 9, 11 and 12.

TROUBLE: BLADE SLIPPING

PROBLEM 1. Tool does not cut workpiece.

REMEDY 1. Assemble blade and tighten Vari-Torque clutch per “Assembly Instructions”, see

(page 8)

WARNING

SM 1619X05346 03-10:SM 1619X05346 03-10 3/10/10 3:15 PM Page 14

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 43 44

Comentários a estes Manuais

Sem comentários

Skil 5680-02 Manual de Utilização e Manutenção Página 14

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas elétricas Skil 5680-02